i just switched out the nylon washers on my 721 with the bronze washers on my 710 since i will be edc'ing my 721.

i just ordered from knifekits.com yesterday and only ordered the barrel spacers for my 710, and i got my 721 today and did the swap.


does anybody have a measuring device that will work on these small washers? so that i can know the exact size to get.

let me know,
thanks,
andrew

This message has been edited. Last edited by: dissipator16,

Why,is it not smooth??????

it is very smooth, but i just like getting rid of nylon/plastic stuff when possible. overall, i like the feel of the bronze washers.

You can get phospher bronze washers at most any electrical parts supply store.

Bring a micrometer or such to measure thickness and an appropriate sized drill bit to determine the size of the inner hole.

i went to an ace hardware and a washer specialty store and came up empty. good point though, i will call some more stores like you mentioned.

could somebody please measure those washers for me? i don't have a micrometer or anything specific like that. i need the inside and outside diameter and the thickness please.

thanks