i just got a 520 , and noticed that the (i believe) .156 barrel spacers that fit a 710, are a little too short for my 520. if i was to order some from knife kits, what size would i need on a 520? i know the thread is 2/56.

thanks in advance

your going to want something in the .165-.170" range and you dont need them to be threaded since the screw goes into the nut inset into the opposite handle. I have a few custom aluminum ones id sell but i have very few left in "check" (1 step in) and "devo" (2 steps) style.

here are some of them installed on my 520.

This message has been edited. Last edited by: 910stryker,

.165" is the size you need.