Hey folks, I need some advice as to how you adjust the pivot screw on a 525. I know how to adjust it on the knives that only has one torx screw but I'm not sure when there are two torx heads. Thanks 29R

Just the same. Tighten them ------> loosen some -----> stop at the sweet spot.

525, easy... loosen the screws on BOTH sides. Slowly (slowly) tighten one side only, not all the way in... while checking pivot tightness/loosness - by opening and closing the knife - tightening the screw on the one side will pull-in the screw on the other side. If you go a bit too far and the blade's a bit tight, just back-off the adjusting screw a hair.